M18×1.5 Mic Mount Nut
AUDIO // STEPThree-wing clamping collar with modeled M18×1.5 metric thread for studio boom stands and heavy shockmounts.
- Bounds
- 62.8×62.8×32.8
- Polymer
- PETG-CF
- Layer
- 0.12 mm
Parametric mechanical parts, reverse-engineered housings, automotive clips, and threaded audio hardware. Designed in FreeCAD and exported to STEP/3MF for high-temp engineering polymers — zero decorative figurines.
Three-wing clamping collar with modeled M18×1.5 metric thread for studio boom stands and heavy shockmounts.
Replacement lever geometry with reinforced square drive tang and custom recessed top grip pattern.
Reconstructed from fractured plastic shell and photo caliper references (R4, R10, 33.7 mm clearance).
Axial crown teeth arranged in polar loft pattern around a square shaft hub with recessed rim engraving.
Multi-body assembly pairing a tapered slotted bracket with stepped alignment rings for tubular hardware.
Snug two-part transceiver/unit shell featuring retention rails, bottom connector cutout, and belt clip backplate.
Snap-fit twin-diameter saddle clip printed vertically for continuous perimeter strength along the flex jaws.
Low-profile 6.4 mm four-lobe torque flange for tool-free tightening of M8 hardware on jigs and stands.
Spreadsheet-driven FreeCAD slider buckle scaled to exact strap width and thickness without mesh distortion.
Compact three-bolt mounting plate with integrated slotted clevis lug and transverse pin bore.
Six-part FreeCAD assembly combining a thin-walled cylinder cup, vertical rail sleeve, and keyhole lock block.
Custom top-mount linear rail X/Y layout with 5 mm flat X beam and Dragon Burner toolhead + EBB36 CAN.
All parts are validated on a custom-built Klipper CoreXY machine tuned for dimensional accuracy, high-temperature engineering polymers, and repeatable press-fits.
| Material | Nozzle | Bed | Use Case |
|---|---|---|---|
| PLA-CF | 230 °C | 55 °C | Jigs, rigid plates |
| PETG-CF | 250 °C | 80 °C | Mounts, audio nuts |
| ABS / ABS-GF | 270–275 °C | 105 °C | Auto trim, heat hoods |
| NYLON (PA) | 260 °C | 105 °C | Gears, wear bushings |
| PP-GF | 250 °C | 80 °C | Chemical / flex clips |
| FLEX (TPU) | 230 °C | 60 °C | Dampers, protective shells |
FORMATS ACCEPTED: STEP / IGES / FCStd / STL / 3MF · Reverse modeling from caliper sketches or broken parts.
STATUS: PROTOTYPING & SMALL-BATCH TECHNICAL RUNS